Propteus is born!

August 14th, 2009

Proteus base board configuration

Propteus is based on the standard 4″x3.05″ Parallax Protoboard format, and has the following features:

Propeller base circuit

  • PropPlug compatible headers, extra pins possible for Vcc, SCL, SDA
  • EEPROM support
  • P8X32 dip support
  • support for FOUR decoupling capacitors for the propeller - two on either side. Saphiea recommends 33uF tantalum and 100nF ceramic on each side for maximum overclocking potential.
  • designed to easily support Sigma-Delta, can cut top trace to second user pad for very short leads
  • optional RESET/user switch

Expansion headers

  • MORPHBUS connector support - or can be used for 2xN headers
  • can be stacked on Morpheus, Propeller ProtoBoard, SX boards, Stamp boards
  • can be “base” board for another Propteyus, Proteus, Mem+, Morpheus
  • two ProtoBoard / Morpheus / SpinStudio compatible ten pin expansion headers
  • expansion headers can be left unconnected, directly connected to P0-P7, P8-P15, or connected via current limiting resistors
  • optionally the EXP1/EXP2 connectors can be driven by other circuitry on the large prototyping area
  • supports extra 1×12 header on bottom left
  • supports 12 servo headers on top right

LED’s - Everyone loves blinking lights!

  • supports four user LED’s with current limiting resistors
  • supports power LED with current limiting resistor

Voltage Regulation

  • support for 3.3V regulator circuit
  • optional power switch
  • filter capacitor support
  • reverse voltage protection diode
  • two pin power input
  • can power MORPHBUS
  • can be powered from MORPHBUS

Servo Power

  • when MORPHBUS powered can be wired to provide 1000uF capacitor and 1uH induction for better external servo power

Large Prototyping Area

  • Large prototyping area designed for better 0.3″ and 0.6″ support
  • Special zig-zag Vcc/GND bus, within 0.1″-0.145″ from any bus

Pricing:

  • Bare PCB $12.95 USD
  • Bare PCB with two short 1×10F, one short 2×20F, one 1×7M connector $14.95 USD
  • Bare PCB with two stacking 1×10F, one stacking 2×20F, one 1×7M connectors $17.95 USD

Prices do not include shipping and handling.

Available NOW!

Propteus stacking daughterboard configurationPropteus stacking daughterboard configurationProteus Servo Header

Proteus base board configurationProteus base board configurationPropteus stacking EXP header detail

Leave a Reply

You must be logged in to post a comment.