Raspberry Pi 3 with RoboPi – works great!
March 12th, 2016It took a bit of fiddling due to changes with the serial port… but
(click on image for larger version)
RoboPi works great with the new Raspberry Pi 3!
Changes needed to get it running:
- add ‘force_turbo=1’ to /boot/config.txt as per forum discussions
- make sure that Serial is set to “Disable” in the Raspberry Pi configurator
- when initializing RoboPi, use /dev/ttyS0 instead of /dev/AMA0
Fact viagra best buy learningworksca.org – this method Will stop anxiety chest pain and heart ailments. Drugs viagra brand online containing nitrates should not be taken when you are suffering from breathing problems, cancer, diabetes, blood pressure, etc. One theory is that excessive anger is caused by the body’s nervous system, and prepare to sildenafil generic from canada fight the threat, causing the blood pressure to decrease severely. It is indicated in conditions like spermatorrhea, premature brand cialis canada ejaculation, neuralgia, incontinence, chronic diarrhea etc.
I must admit that I was concerned about changing the serial port on the GPIO header to the mini Uart, but these changes are relatively painless.
RoboPi is supported on the seven Raspberry Pi’s:
- Raspberry Pi 3 Model B (***NEW***)
- Raspberry Pi Model A
- Raspberry Pi Model B
- Raspberry Pi Model A+
- Raspberry Pi Model B+
- Raspberry Pi 2 Model B
- Raspberry Pi Zero
RoboPi is also supported on six other single board computers:
You read right – RoboPi is now supported on 13 different SBC’s!
